Amprobe AT-5000 Underground-Wire-Tracer User Manual download pdf (Page 38)

Begin to trace the cable from the point of application about 50-FT (15m) away6.

Move slowly over the cable. Decrease or increase the sensitivity as needed7.

Direct Coupling using the SC-5000 Clamp

Plug the SC-5000 clamp into the T-5000 transmitter connection socket1.

Place the clamp around the pipe or cable2.

Switch the T-5000 transmitter on3.

Set the T-5000 transmitter to the desired signal transmission4.

Switch the R-5000 Receiver on5.

Set the R-5000 Receiver to the desired signal reception6.

Begin to trace the cable from the point of application about 15m away7.

Inductive Coupling

1. Position the T-5000 transmitter above the presumed cable

2. Switch the T-5000 transmitter on

3. Set the T-5000 transmitter to the desired signal transmission mode

4. Switch the R-5000 receiver on

5. Set the R-5000 receiver to the desired signal reception mode

6. Begin to trace the line from the transmitter at least 15m away.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 255 256

No comments

Amprobe AT-5000 Underground-Wire-Tracer User Manual Page 38