Amprobe AT-7000 User Manual download pdf (Page 31)

Figure 4.10b

Figure 4.10c

7. PRESS ENTER when complete to return to home screen.

*Note: For best results, keep the receiver at least 3 feet from the transmitter and its test

leads to minimize signal interference and improve wire tracing results.

4.11 Locating Loads (Signal Clamp)

The clamp accessory can be used to map loads to

specific breakers on both energized and

de-energized systems. There is no need to

disconnect power.

1. Clamp the SC-7000 around the wire at the

breaker panel.

2. Set up the transmitter and receiver as described

in the previous section 4.10 “No Access to Bare

Conductors (Inductive Clamp)’.

3. Scan face plates of receptacles and wires

connecting loads with the TIP Sensor of the

AT-7000-R. If using on a de-energized system

you must set the receiver to de-energized TIP

SENSOR mode.

4. All the wires, receptacles and loads that have a

strong signal as indicated by the AT-70000-R are

connected to the breaker.

4. SPECIAL APPLICATIONS

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 109 110

No comments

Amprobe AT-7000 User Manual Page 31