Amprobe AT-7000 User Manual download pdf (Page 21)

Using AT-7000-R Receiver

1. Press ‘ON/OFF’ push button to turn on the receiver and wait for the home screen (boot

up time is around 30 seconds).

2. Select De-Energized TIP SENSOR mode by using the directional arrows to highlight this

operating mode and pressing the yellow “ENTER” button. Screen will appear as shown

in Figure 3.2c

3. Hold the receiver with the Tip Sensor facing the target area.*

4. Scan target area with Tip Sensor to find highest signal level. While tracing, periodically

adjust sensitivity to keep signal strength near 75. Increase or decrease sensitivity

by pressing + or – on the keypad. If signal is too strong for precise locating, change

transmitter to LOW mode.

0-30V AC/DC

TIP SENSOR DE-ENERGIZED

SIGNAL

Figure 3.2c

5. Press ENTER when complete to return to Home screen.

*Note: For best results, keep the receiver at least 3 feet from the transmitter and its test

leads to minimize signal interference and improve wire tracing results.

De-energized mode uses a different antenna in the Tip Sensor than in energized mode.

Specific alignment of the Tip Sensor groove to the wire is not required. De-energized wire

tracing results are based only on how close the Tip Sensor is to the wire.

3. MAIN APPLICATIONS - TIP SENSOR (De-Energized)

TIP SENSOR

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 109 110

No comments

Amprobe AT-7000 User Manual Page 21