Amprobe AT-7000 User Manual download pdf (Page 19)

Using AT-7000-R Receiver

1. Press ‘ON/OFF’ push button to turn on the receiver and wait for the home screen (boot

up time is around 30 seconds).

2. Select Energized TIP SENSOR mode by using the directional arrows to highlight this

operating mode and pressing the yellow “ENTER” button. Screen as shown in 3.1i will

appear.

3. Hold the receiver with the Tip Sensor facing the target area.

4. Scan target area with Tip Sensor to find highest signal level. While tracing, periodically

adjust sensitivity to keep signal strength near 75. Increase or decrease sensitivity

by pressing + or – on the keypad. If signal is too strong for precise locating, change

transmitter to LOW mode.

5. Receiver Positioning: For best results, align groove on tip sensor with wire direction as

shown. Signal may be lost if not properly aligned. (see Figure 3.1g)

6. To verify wire direction, periodically rotate receiver 90 degrees. Signal strength will be

highest when wire is aligned with Tip Sensor groove. (see Figure 3.1h)

7. Press ENTER when complete to return to Home screen.

Note: For best results, keep the receiver at least 3 feet from the transmitter and its test

leads to minimize signal interference and improve wire tracing results.

Figure 3.1g

Figure 3.1h

Figure 3.1i

Receiver showing signal detected in

Energized TIP SENSOR mode

0-30V AC/DC

TIP SENSOR DE-ENERGIZED

SIGNAL

3. MAIN APPLICATIONS - TIP SENSOR (Energized)

TIP SENSOR

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 109 110

No comments

Amprobe AT-7000 User Manual Page 19